The Library


The Library has 4 main sections. Patches, Clips, Plugins and Tools.



This image shows a collection of Patches. You can filter the patches by selecting a Projects at the left hand side, and create a new patch by pressing on the 'Create Bus Patch'. More information on the Patches page.

Patches are accessed by clicking on its 'Rack' thumbnail.



Clips are grouped by folders, you can filter the clips by selecting a folder at the left hand side. Clips are loaded by dragging and dropping the thumbnail onto any of the navy blue rectangles in the Slot details panel or Rack.


plugins library

Plugins can be loaded by dragging and dropping them into an empty FX Stack slot (seen just above the Plugins tab). Most Plugins require a source clip to effect, but some Plugins can act as a source and these are coloured gold, and some are Mixer plugins, coloured blue.




You can keep a backup of your Library by just cloning/copying or rsync'ing the iQSynth folder. However as your Library grows this can become impractical. This is where the Library Sync tool could be used. You can use this is keep sync with a backup and/or you can use it to design on desktop / sync with gig machine / create-record during a show / and finally sync back to your desktop machine and backups.

There are a few limitations at this time, Application and Midi configurations are not synced and the Libraries are only merged i.e. deletions are NOT respected, this is a to do, unless you delete the content from each instance it will reappear in your Library during a re-sync.